Recommendation A16-03

Assesssment of the response to Aviation Safety Recommendation A16-03

ELT system crash survivability standards – FAA (on behalf of RTCA)

View document in PDF

You need a PDF reader to access this file. Find out more on our help page.

Background

On 31 May 2013, at approximately 0011 Eastern Daylight Time, the Sikorsky S-76A helicopter (registration C-GIMY, serial number 760055), operated as Lifeflight 8, departed at night from Runway 06 at the Moosonee Airport, Ontario, on a visual flight rules flight to the Attawapiskat Airport, Ontario, with 2 pilots and 2 paramedics on board. As the helicopter climbed through 300 feet above the ground toward its planned cruising altitude of 1000 feet above sea level, the pilot flying commenced a left-hand turn toward the Attawapiskat Airport, approximately 119 nautical miles to the northwest of the Moosonee Airport. Twenty-three seconds later, the helicopter impacted trees and then struck the ground in an area of dense bush and swampy terrain. The aircraft was destroyed by impact forces and the ensuing post-crash fire. The helicopter's satellite tracking system reported a takeoff message and then went inactive. The search-and-rescue satellite system did not detect a signal from the emergency locator transmitter (ELT). At approximately 0543, a search-and-rescue aircraft located the crash site approximately 1 nautical mile northeast of Runway 06, and deployed search-and-rescue technicians. However, there were no survivors.

The Board concluded its investigation and released report A13H0001 on 15 June 2016.

TSB Recommendation A16-03 (June 2016)

In this occurrence, as in numerous others investigated by the TSB,Footnote 1 the Emergency Locator Transmitter (ELT) system was rendered inoperative nearly immediately or within seconds following impact by damage sustained during the crash sequence. As a result, the ELT was unable to transmit a distress signal to the Cospas-Sarsat SAR satellite system. In many instances, ELT signals have not reached the Cospas-Sarsat system due to a broken antenna or a break in the wire connecting the ELT unit to the antenna. In this occurrence, it was determined that although the ELT unit was operable, a broken ELT antenna prevented the signal from being transmitted. The crashworthiness design specifications are robust for the actual ELT unit; however, the specifications are significantly less stringent for the other key components (i.e., the wiring and antenna) of the ELT system.

One of the inherent limitations of a 121.5 MHz ELT is its requirement for a whip-style antenna, which extends outward from the aircraft fuselage, significantly increasing the likelihood that it will be damaged or broken by impact with terrain, trees, or other parts from the aircraft during a crash sequence. Modern 406 MHz ELTs permit the use of low-profile (i.e., flush-mounted) antenna installations, which are significantly less susceptible to such damage. Transport Canada (TC) has recently issued a Notice of Proposed Amendment (NPA) that would mandate 406 MHz ELTs; however, the NPA also states that the regulation will mandate the carriage of dual 121.5-/406 MHz ELTs. According to TC, retaining the 121.5 MHz requirement for new 406 MHz ELT installations, in accordance with Technical Standard Order (TSO) C126b, is to allow for homing. If these dual-frequency units are designed to use a single antenna, that antenna would need to be whip-style to accommodate the 121.5 MHz frequency. Some 406 MHz ELT units now come equipped with a backup, internal global positioning system (GPS) receiver and antenna that meet the specifications of Radio Technical Commission for Aeronautics (RTCA) RTCA DO-204A and European Organisation for Civil Aviation Equipment (EUROCAE) document ED62A. However, the internal antenna has not been tested and approved by Cospas-Sarsat, whose standard does not include details on the design's radiation and power output. Finally, depending on the location of the ELT unit, the signal from an ELT using an internal antenna may be emitted at a reduced effectiveness due to shielding from aircraft components or terrain. TC has indicated that it will not stipulate a dual-antenna requirement for new dual 121.5/406 MHz ELTs. As a result, if the design standards allow for a single antenna, versus separate 121.5 MHz and 406 MHz antennas, to be used on dual-frequency units, the risks associated with the use of a whip-style antenna will persist.

The International Civil Aviation Organization (ICAO) establishes International Standards and Recommended Practices for member states. However, it has not established any ELT system design standards; these are currently determined by national regulatory bodies such as TC, the Federal Aviation Administration (FAA), and the European Aviation Safety Agency (EASA). In Canada, Canadian Aviation Regulations (CARs) Part V—Airworthiness Manual (Chapter 551: Aircraft Equipment and Installation) states that ELTs must meet the performance standards for 121.5 MHz and 406 MHz ELTs set out by the RTCA. In the United States, although there is no regulatory requirement for 406 MHz ELTs, the FAA only accepts requests for new ELT technical standard order authorizations for 406 MHz ELTs. As in Canada, the FAA relies on the performance specifications set out by the RTCA. In Europe, EASA has taken a similar approach, requiring that ELTs meet the design specifications set out by EUROCAE. A considerable body of research now indicates that current ELT design standards do not ensure a reasonable degree of crash survivability.

As a result, it is highly likely that aircraft equipped with ELT systems that meet the current design standards will continue to be involved in occurrences in which potentially life-saving SAR services will be delayed as a result of damage to the ELT system, decreasing the survivability of an accident.

Therefore, the Board recommended that

The Radio Technical Commission for Aeronautics establish rigorous emergency locator transmitter (ELT) system crash survivability specifications that reduce the likelihood that an ELT system will be rendered inoperative as a result of impact forces sustained during an aviation occurrence.
TSB Recommendation A16-03

FAA's response to Recommendation A16-03 (January 2017)

In December 2013, the RTCA Program Management Committee established Special Committee SC-229, 406 MHz Emergency Locator Transmitters (ELTs), to develop a Minimum Operational Performance Standard (MOPS) for second generation ELTs. As part of the Terms of Reference, the committee is developing cabling, antenna, and crash safety specifications for first and second generation ELTs. Special Committee SC-229 is expected to publish the revised MOPS in March 2018. The FAA will provide an updated response 60 days after the MOPS is published.

We expect to provide an updated response to Safety Recommendation A16-03 (FAA file number 16.133) by June 1, 2018.

Board assessment of FAA's response to Recommendation A16-03 (March 2017)

The Board is pleased to hear that the committee is developing cabling, antenna, and crash safety specifications for first and second generation ELTs, and that a specific deadline has been set for the completion of this work.

However, until the new specifications are available for review, the Board is unable to determine if the new standards, once fully implemented, will substantially reduce or eliminate the safety deficiency associated with Recommendation A16-03.

Therefore, the response to Recommendation A16-03 is assessed as Satisfactory Intent.

Next TSB action

The TSB will monitor the progress of RTCA's actions to mitigate the risks associated with the safety deficiency identified in Recommendation A16-03, and will reassess the deficiency on an annual basis or when otherwise warranted.

This deficiency file is Active.

Footnotes

Footnote 1

TSB aviation occurrences A09Q0111, A09Q0190, A10A0041, A10A0122, A10O0125, A10O0145, A10O0240, A10P0142, A10Q0098, A10Q0111, A10Q0132, A11C0047, A11P0117, A11W0151, A12C0005, A12O0170, A12P0070, A13C0150, A13P0127, and A13W0009.

Return to footnote 1 referrer